Image-based validation example

Before you start recording, let’s define the test.  It consists of five steps:

1. Start the demo application.

2. Click the Image-based automation tab.

3. Make the image visible.

   

4. Verify that the image is displayed.

5. Exit the Demo Application.

1. Demo App selected as AUT and is launched automatically when you start recording. When the Solution Wizard has finished, click the Recording1 tab in the Ranorex Studio working environment.

1. In the recording module view of Recording1, click RECORD. Ranorex Studio is minimized to the taskbar automatically
   The Recorder control center shows that the recording is active.
   
2. The application under test comes into focus. Click the tab Image-based automation.
3. To make the image appear, click the checkbox Show image.
   
   1.  

The goal of the example validation is to verify whether the image of the cat appears when the checkbox is selected. Since this requires us to validate an image, it’s an image-based validation. Follow the steps below:

Activate image-based validation

1. In the Recorder controls, activate the switch Image-based recording

2. Click Validate. The Recorder pauses recording and switches to image-based validation mode
   

3. Select the UI element to validate:
   Mouse over the image of the cat. A purple frame follows your mouse movement.
   The purple frame indicates which element is currently selected for validation.
   Once your selection matches the image, click it.
   
   

4. To confirm the UI element, click Next.
   
   

1. 1. UI element location within GUI
      The UI element tree represents the hierarchical GUI structure of the application.
      You can click a different UI element to select it for validation if desired.

   2. UI element states and attributes
      All the attributes of the selected UI element appear in this area.

   3. Screenshot of validation UI element
      Use the screenshot to quickly check whether you’ve selected the correct UI element.Define the image that will be used for the validation. For our example, simply leave everything as it is and click OK to confirm.

1. 1. The Image tab is selected in the validation dialog instead of the Attributes tab.

   2. Draw a rectangle to select a part of the image when using the “Contains” validation mode.

   3. Different image validation modes are available:
      

• • • None: deactivates image validation.
    • Contains: determines whether the validation image is contained in the actual image found during the test.
    • Compare: determines whether the validation image and the actual image found during the test are the same.

Once you’ve finished the validation action, Ranorex automatically continues recording. The next step is to end the test recording.

1. In the Recorder control center, click Stop to end the recording.
   

After the recording stops, you are returned to Ranorex Studio. You’ll see the actions table with three recorded actions. Action #3 is the validation action.

1. Validation type operator: This operator identifies the type of validation to perform. There are nine different validation type operators.
   
   A detailed description of all validation match operators can be found in Action properties.

2. The validation screenshot to which the actual image found during testing will be matched.

3. The repository item linked to the action, i.e. the UI element on which the validation is performed.

Interpreting the validation

If written as a statement, the validation would read as follows:

If Screenshot1 is contained (ContainsImage) in the UI-element referenced by the repository item TheCat, THEN the validation returns the value ‘True‘.